User's Manual

22
ITS Introduction
The PRO PLM may be used as a ITS (Interior Theft Sensor) and when doing so it is designed to honk the horn if a
light impact is detected or trigger the vehicle's factory alarm if a harder impact is detected.
Note: The vehicle MUST have a factory alarm that is triggered by opening the vehicle's door.
Option #10 must be changed in the feature programming bank for the system to function as the ITS.
Optional Warn Away
The optional Warn-Away Trigger is active after the ignition key is turned off and the dome light shuts off after exiting
the vehicle. When a light impact is detected the system will briefly honk the vehicles horn. If at any time a door is
opened (dome light "on"), the Warn-Away Trigger will be bypassed until the ignition key is cycled "ON" and "OFF".
This feature prevents the Warn-Away chirps of the vehicle's horn when the customer/user enters the vehicle. The
Warn-Away Trigger will reactivate when the ignition key is cycled "ON" and "OFF" again.
Factory Alarm Trigger
The ITS Factory Alarm Trigger is active 5 minutes after the ignition is turned off and the factory alarm has been set.
When a heavy impact is detected the ITS will pulse the vehicle's door trigger wire to active the factory alarm.
Valet Mode
Valet Mode deactivates both the optional Warn-Away and Factory Alarm Trigger. To turn Valet Mode ON, turn the
ignition key ON/OFF three times. To turn Valet Mode "OFF", turn the ignition key ON/OFF three times.
Harness Connections
DK BLUE - Factory Alarm Trigger: Connect this to a wire which triggers the vehicle's factory alarm system such as
the door ajar, hood or trunk wire.
PURPLE and BROWN - Door Inputs (+/-): Connect one of these wires to the vehicle's dome light wire.
RED - +12 Volt Input: Connect this wire to constant +12 volt source.
BLACK - Ground Input: Connect this wire to chassis ground.
YELLOW - Ignition Input: Connect this wire to +12 volt ignition source.
BLACK/WHITE - Warn Away Horn Output: Connect this wire to the vehicle's horn wire.
NOTES:
The ITS uses the PURPLE or BROWN (Door Input) to DISARM the optional Warn-Away feature. The PURPLE or
BROWN must sense all of the doors for the ITS to DISARM properly. It is recommended to only use the Warn-Away
feature with vehicle's that have an "ALL" door trigger output in the vehicle.
ITS ACTIVATION
ITS FUNCTIONALITY