User's Manual

When Your Security System is Triggered, Continued

Attempted Intrusion Identification

Pressing UNLOCK after a full 30 second trigger cycle has completed, the horn will honk 4 times and the

LED will flash a number of times to indicate which input triggered the alarm. Turning on the ignition or

pressing the valet/override button will reset the LED flashes, pressing the valet/override button will also

honk the horn to match the LED flashes before it resets.

Number of flashes:

1 - Interior Theft Sensor (Shock Sensor)

2 - Door Input

3 - Hood Input

4 - Trunk Input

5 - Ignition

Emergency Disarm Procedure

If your remote control is lost or fails to function, use this procedure to disarm the MM1 Security System

and start your vehicle.

1 - Use the keys to enter the vehicle. The alarm will sound once the door is opened.

2 - Insert the key into the ignition and turn to the ON position.

3 - Locate and press the emergency override button. The alarm will turn off and then you will be

able to start the vehicle.

Your Emergency Override Button is Located:

_________________________________________

Basic Trouble Shooting

Symptom Problem Solution

Remote does not work: Weak or dead battery. Change battery.

System will not arm: Door or entrance is open. Close entrance.

Courtesy light is on. Turn courtesy light off.

System is in Valet mode. Exit Valet mode.