PROPLM Owner's Manual Keyless Entry Upgrade Security System IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
Table of Contents Features and Benefits ............................................................... 3 System Functions ...................................................................... 4 Arming the system Pre-arm mode Disarming the system Using valet mode When Your Security System is Triggered ............................... 4 When Your Security System is Triggered, Continued ............ 5 Attempted Intrusion identification Emergency Disarm Procedure ............................................
Features and Benefits Two Easy-to-Use Weather-Resistant Remote Controls The upgrade security system utilizes your factory keyless entry remote controls and adds a complete vehicle security system while retaining factory functions. All Entrances Protected Opening any door or entrance protected by the security system triggers the vehicle’s horn and flashes the parking lights. Starter Disable The PROPLM Security System protects your vehicle from theft by disabling the starter when the system is armed.
System Functions Arming the Security System To arm the system, exit the vehicle, close all doors, then press the LOCK button on your keyless entry remote control. The system will flash the parking lights 2 times, indicating the system is armed, and activated the starter disable feature. The status indicator (LED warning light) will blink steadily, once per second.
When Your Security System is Triggered, Continued Attempted Intrusion Identification Pressing UNLOCK after a full 30 second trigger cycle has completed, the horn will honk 4 times and the LED will flash a number of times to indicate which input triggered the alarm. Turning on the ignition or pressing the valet/override button will reset the LED flashes, pressing the valet/override button will also honk the horn to match the LED flashes before it resets.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. Per FCC 15.21, you are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.
