MODEL RST560A REMOTE ENGINE STARTER WITH ALARM SYSTEM OWNER’S MANUAL OPERATION: A. REGULAR TRANSMITTER OPERATION: Transmitter System Function Remark Button 8 Lock Doors & Arm System 8-8 Arm and Delete The 2 Stage Shock Sensor Press twice within 5 seconds, a Car locator Upon Armed {3-second} Panic function Press and Hold for 3 seconds ) Unlock Doors & Disarm Stern fis I | Two Steps Door Unlock & Disarm System Press twice within 3 seconds. B+m Silent Arming / Disarming BR (2.
F. ACTIVE LOCK & ARM: 1. Press Bl button on the transmitter. 2. The horn will chirp once and parking light will flash once Indicating that the system is now armed. The vehicle doors will lock upon arming when interfaced with the security system. SILENT ARMING / DISARMING: Press @ and al bunions at the same time on the transmitter will arm or disarm your security system, No chirp sound will be heard, arm / disarm confirmation will be through the vehicles parking lights only.
2. Push and hold valet switch for 2 seconds until the LED turns on. The LED wills remain on as long as the system is in ‘valet mode’. Exit Valet Mode: 1. Return to normal operation, turn ignition ‘on’. 2. Push and hold valet switch for 2 seconds, The LED wills turns off indicate the system are exiting the valet mode. J. PANIC FUNCTION: The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency. 1. Press and hold the Ml button for 3 second.
A. TO REMOTE START THE VEHICLE: When you want to start your vehicle, 1. Press % button twice on the transmitter. 2. The parking light will activate to indicate the remote start received the signal. 3. The engine will start approximately § seconds. 4. Once the engine is running, after couple secondhand parking light will turn on again and climate controls will activate and adjust the vehicles interior temperature to your preset setting. 5.
2. Immediately depress RS button once, within 2 seconds 3. Rapidly depresses %* button. The parking light will flash (3) times. The siren or hom chirps (3) times, The vehicle is now programmed to start every 3 (2) hours. 4. Press the brake pedal to stop the vehicle running: Exit the timer start: Timer start can be exited manually as follows: 1. Make sure the remote start system is not operating the engine. 2. Tun the ignition on. The LED and parking light will flash (4) times.
