User's Manual

2
Active arming Passive arming
without passive door
locking
Passive arming with
passive door locking.
3
Ignition controlled
door locks & unlocks
Without ignition
controlled door locks
& unlocks
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps will confirm exit.
ALARM FEATURE “III” PRORAMMING:
1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 6 times and hold in on the 6
th
push; when a long chirp is
heard, then release the valet switch. You are now in the Alarm feature ‘III’
programming mode.
3 Press the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
1
H1/4 Brown Wire =
Siren Output
H1/4 Brown Wire =
Horn Output
2
H2/6 Gray Wire = Trunk
(Channel 2) Output
H2/6 Gray Wire = Two
Step Door Unlock
Output
H2/6 Gray Wire = Pager
Output
3
Car Jacking Off Car Jacking On
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps will confirm exit
ALARM FEATURE “IV” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 8 times and hold on the 8
th
push until FOUR chirps with a long
chirp is heard then release the valet switch. You are now in the Alarm feature ‘IV’
programming mode.
3. Press and hold the transmitter button for two seconds to enter shock sensor
program mode.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default Setting
Two Chirps /
LED two pulse
1
Shock Sensor Program Mode
ADJUST AND TEST THE SENSITIVITY LEVEL OF THE SHOCK SENSOR
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 8 times and holding in on the 8th push until four chirps with a
long chirp is heard then release the valet switch. You are now in the Alarm feature
‘Shock Sensor’ programming mode.