User's Manual

MAY/24/2005
560A 4
#H5 5 PIN WHITE CONNECTOR FOR OUTPUT CONNECTION
3. White Wire: (-) 200 mA Programmable output
Dome Light Control Output (Factory Default setting)
Or Horn Output
Or Factory Security Rearm Signal Output
Or Ground Output During Start (Crank)
1. Orange Wire: (-) 500mA Grounded Output When Armed
5. Gray Wire: (-) 200 mA Channel 3 (Trunk) Output
2. Yellow Wire: (-) 200 mA Ignition 3 Control Output
4. Pink Wire: (-) 200 mA Programmable output
2-Step Door Unlock Output (Factory Default setting)
Or Factory Security Disarm Signal Output
Or Start Status (Shock Sensor Bypass Control) Output
#H6. 7 PIN BLACK CONNECTOR FOR INPUT CONNECTION:
2. Green
Wire:
Zone 3
Negative Door Pin Trigger Input:
1. Blue Wire: Zone 2 Instant Trigger Ground Input
3. Violet
Wire:
Zone 3
Positive Door Pin Trigger
5. White/Violet
Wire: (
+
) Positive Safety Shut Down Input for Brake switch.
6. Black/White
Wire: (
-
) Neutral Safety Switch Input &
(
-
) Remote Start Toggle Switch Input
7. White/Red
Wire: Tach. Signal Input
+12V
4. White/Black
Wire: (
-
) Negative Safety Shut Down Input for Hood pin switch
IMPORTANT NOTE:
Directly connect the H6/6 BLACK/WHITE wire to the “GROUND” when this wire
is not used.
+12V