User's Manual

MAY/24/2005
560A 13
The system has built-in a two stage shock sensor. You can use “Test Mode” to test and adjust the shock
sensor sensitivity.
1 Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 Push the Valet switch 6 times and holding in on the 6
th
push until three chirps with a long chirp is
hearing then release the valet switch.
3 Press the
button on the transmitter to enter the Shock Sensor Test mode, two chirps and two
LED flashes to indicate your are in the shock sensor test mode.
4 A light impact to the vehicle will activate the warn-away (first stage shock sensor/ Zone 1), system will
emit a short chirp.
5 A more forceful impact will activate the full alarm (second stage shock sensor / Zone 4), system will
emit a long chirp.
6 Continue to test the shock sensor until reach the proper sensitivity.
NOTE: Using a small screwdriver gently turns the adjustment screw
1. Turn the sensitivity adjustment screw to the “
– “ (anti-clockwise) direction for decreasing the
sensitivity.
2. Turn the sensitivity adjustment screw to the “
+ “ (clockwise) direction for increasing the sensitivity.
Exit: Turn Ignition to 'ON' position then A 3 long chirps & 3 parking light flashes to confirm exit.
REMOTE START FEATURE PROGRAM MODE.
START FEATURE “I” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 8 times and holding in on the 8
th
push until four chirps with a long chirp is hearing
then release the valet switch. You are now in the Start feature ‘I’ programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Gasoline Engine Diesel Engine and
10 seconds
warn-up timer
Diesel Engine and
15 seconds
warn-up timer
Diesel Engine and
20 seconds warn-up
timer
2
10 minutes run time 20 minutes run time 30 minutes run time 5 minutes run time
3
Factory alarm disarm
with channel 3 on
Without this feature
4
Constant parking light
output
Flashing parking
light output
5
+
Press
-
button = Activate
Remote Start.
Press
+
button = Activate
Remote Start.
Press
button =
Activate Remote
Start.
The Vehicle has
aftermarket Turbo
timer installed:
The system Can be
Arm with the engine
running and the
shock sensor will be
bypass as long as
the engine running.
The Vehicle has
aftermarket Turbo
timer installed:
The system Can be
Arm with the engine
running and the
shock sensor will be
bypass for three
minutes
Built-in Turbo Timer
Control is Active:
Press
and
buttons at the same
time to control
Engine running one
minute.
6
+
The Vehicle without
Turbo (The system
Cannot be Arm with
the engine running)
Five chirps = Built-in Turbo Timer Control is Active / Press
and
buttons at the same time to control Engine running three
minutes.
Six chirps = Built-in Turbo Timer Control is Active / Press
and
buttons at the same time to control Engine running five
minutes.
7
+
3 Hour Time start 2 Hour Time Start
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
SAFE START (Child safety mode)