User's Manual

MARCH/31/2004
560A 5
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”
SAFE START (Child safety mode) (See Start Feature I – 5 Programming.)
Factory defaults setting to press the
button twice on the transmitter to start the vehicle. Programming
this feature to eliminate an accidental remote start, when kids enter this transmitter, it enquires:
The user presses the transmitter
and buttons at the same time to start the vehicle.
B. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button twice on the transmitter.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate engine stopped.
C. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:
To operate the vehicle while running on the remote start.
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down.
D. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the ignition. This
feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but
would like to leave the motor running and the climate control on.
1. Before turning off the engine, press
button twice on the transmitter and the LED indicator will
flash 3 times to confirm enter.
2. Turn the ignition key to OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapsed or shutdown input is received.
E. TURBO TIMER MODE: (See Start Feature “I - 6” Programming)
Turbo timer mode keeps the engine running after arriving at you destination for a programmable period of
1/ 3 or 5 minutes, This allows the system’s time to conveniently cool down the turbo after you have left the
vehicle. To activate:
1. While engine is running, place the transmission gear in the park position and pull up the hand brake.
2. Before turning off the engine, press and release
and buttons at the same time.
-- The parking light wills turn on to indicate the remote start has entered turbo charge mode. --
3. Pull off the “Ignition Key” from the key cylinder.
-- Engine keeps running. --
4. Exit and secure the vehicle.
-- Engine continues running until the pre-programmed time elapsed. --
F. TIMER START:
This unit can be programmed to start and run the engine every 3 (2) hours. The engine will run for the
programmed run time and then shut down.
IMPORTANT: Timer Start should be used only in open areas, never start and run the vehicle in on
enclosed space as a garage or carport.
3 (2) hours timer start: This feature is design for an extreme cold climate usage. The system will auto
start the vehicle every 3 (2) hours, to prevent engine freezing and hard to start. A MAXIMUM OF SIX
CYCLES CAN OCCUR.
ENTER:
1. Press
button twice to remote start the vehicle. As soon as the vehicle is running and the parking light
have turned on or flashing.
2. Immediately depress
button once, within 2 seconds
3. Rapidly depresses
button. The parking light will flash (3) times. The siren or horn chirps (3) times.
The vehicle is now programmed to start every 3 (2) hours.
4. Press the brake pedal to stop the vehicle running.
Exit the timer start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The LED and parking light will flash (4) times. The siren or horn chirps (4) times.
Or
1. Press
button twice to remote start the vehicle. As soon as the vehicle is running and the parking light
have turned on or flashing.