User's Manual

APRIL/18/2004
3
D. ALL CODES BACK TO DEFAULT:
1 Enter the “MAGNADYNE Master Code” (7352000) on the keypad; the beeper will emit a long chirp to
confirm the correct code was entered.
2 Press the “LOCK” key on the keypad and holding in for 5 seconds until five beeps is hearing then
release the “LOCK” key
3 The system will re-program all codes back to default. (Default dealer code is 12345 and user code is
54321)
E. RE-PROGRAM THE DEALER CODE: Default Dealer Code is 12345
1. Enter the “Dealer Code” on the keypad; the beeper will emit a long chirp to confirm the correct code was
entered.
2. Press the “LOCK” key on the keypad and holding in for 2 seconds until five beeps is hearing then release
the “LOCK” key.
3. Enter the new 4 – 6 digit dealer codes on the keypad. (The dealer code can be 4, 5 or 6 digits.)
4. Finish by press the “LOCK” key on the keypad one long beep with 2 short beeps to confirm the new
dealer code has been stored into memory and the all user code was back to default setting (Default user
code is 54321).
Exit: If 15 seconds of inactivity expire during of above steps, the unit will revert back to the last successfully
stored code. 3 long beep to confirm exit.
F. PROGRAM THE USER CODE: Default Dealer Code is 54321
Note: This mode will only retain the last 4 “user code” programmed. If the “user code” memory is exceeded,
the system will start deleting “user code” from memory in chronological order.
1. Enter the “Dealer Code” on the keypad; the beeper will emit a long chirp to confirm the correct code was
entered.
2. Enter the new 4 – 6 digit user codes on the keypad. (The user code can be 4, 5 or 6 digits.)
3. Finish by press the “LOCK” key on the keypad one long beep with 2 short beeps to confirm the new
dealer code has been stored into memory.
4. If you have additional user code (up to 4) that needs to be programmed, repeat step 2 and 3 for each new
user code.
Exit: Press and hold the “LOCK” key for 1 seconds or If 15 seconds of inactivity expire during of above
steps, the unit will revert back to the last successfully stored code. 3 long beep to confirm exit.
OPERATION:
A. 4-BUTTON TRANSMITTER OPERATION:
Transmitter Button System Function Remark
Lock The Vehicle’s Doors and
Cargo Door
Parking light one flash.
Unlock The Vehicle’s Doors 1. Parking light two flashes.
2. Dome light turns on for 30 seconds
3. Porch light turns on for 30 seconds
Lock The Cargo Door
Unlock The Cargo Door
+
Turns On the Porch Light for 30
seconds or Turns it Off
Upon Vehicle’s Door Unlock
B. 3-BUTTON TRANSMITTER OPERATION:
Transmitter Button System Function Remark
Lock The Vehicle’s Doors and
Cargo Door
Parking light one flash.
Unlock The Vehicle’s Doors 1. Parking light two flashes.
2. Dome light turns on for 30 seconds
3. Porch light turns on for 30 seconds
Turns On the Porch Light for 30
seconds or Turns it Off
Upon Vehicle’s Door Unlock