User's Manual

APRIL /29/2004
400S 美 13
a). 50 seconds after the system has beer triggered. The siren will start chirping for 15 seconds.
b). During this 15 seconds period of chirping, you will be alerting to push the valet switch once to turn off the
car-jacking feature. If not, it will enter second timer car jacking.
c). 65 seconds after the system has beer triggered. The siren starts alarming and the parking light starts
flashing.
d). 90 seconds after the system has beer triggered
1. The siren still alarming and the parking light flashing, and
2. The starter disable will activate to prevent the vehicle from starting.
3. It will remain active until the vehicle's battery power exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and the
system disarmed
Note: If you use password pin code to double protect the vehicle security, you will need to use it to
completely disarm the system.
O. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
The alarm with a unique feature which will turn on your vehicle dome light as following:
1. Upon disarming, the interior lights will remain on for 30 seconds.
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn ON the ignition switch or arm the alarm will turn off the dome light.
P. IGNITION CONTROL POWER DOOR LOCK SAFETY SYSTEM. (See Feature II – 3
Programming.).
1. Turn the ignition switch on and close all vehicle’ s doors. After 3 seconds, the system will automatically
lock the central locking system.
2. Turn the ignition switch off. The system will automatically unlock the central locking system.
Q. TRUNK RELEASE (Factory default setting) / CHANNEL 3 TIMER CONTROL
OUTPUT. (See Alarm Feature III – 3 Programming.)
Press and hold the button on transmitter for two seconds to remote control the trunk release or other
electric devices.
Channel 3 is user-programmable timer output. You may program the built-in timer to send a ground signal for
any time interval between 1 second and 2 minutes. For instance, this timer output may be used to turn on
the headlight, power window or sunroof.
Note: Factory default setting at 1 second pulse grounded for trunk release output.
R. CHANNEL 4 TIMER CONTROL OUTPUT (See Alarm Feature III – 4 Programming.)
Press the transmitter and button at same time to active Channel 4 function.
Channel 4 is user-programmable timer output. You may program the built-in timer to send a ground signal for
any time interval between 1 second and 2 minutes. For instance, this timer output may be used to turn on
the headlight, power window or sunroof.
Note: Factory default setting at momentary output.
S. SECOND VEHICLE SECURITY OPERATION:
Your 4-button remote transmitter can be utilized to control a second vehicle security system, To program the
remote control transmitter to a second vehicle, follow the instructions for Transmitter programming. All
programming parameters be the same except for the following:
1. Prior to pushing any button on the transmitter. Press the Select button first on the transmitter.
2. Once button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the
second transmitter pin code has built-in.
While the LED is illuminated, press any button on the remote control transmitter to control a second vehicle security system.
T. POWER ON MEMONRY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if the power
is lost and then reconnected.