User's Manual

5
User Discretion Silent Arming:
Your security system can be instructed to become armed or disarmed without the horn/siren chirps by the
transmitter. To operate this feature at any time, simply press the LOCK and UNLOCK buttons at the same time
to arm or disarm your security system without the chirp indications.
60 Second Rearming:
If your Carbine security system has become triggered, the horn/siren will sound for 60 seconds and then stop
and reset to a fully armed condition.
Note: If a protected entrance is left open, your security system will remain triggered for two more 60 second
cycles then fully rearmed excluding the door input trigger (door input trigger is no longer functional). Closing
the entrance will reset the door input trigger within 7 seconds.
Secondary RF Protection Mode:
Every time you disarm your security system with your transmitter, the security system will start an RF
protection mode countdown. This is a timed secondary protection mode to ensure that after the system is
disarmed by radio signal, it will count down for 60 seconds and then become rearmed if no one enters the
vehicle.
Note: This feature is only active when the security system has been programmed to automatically arm.
Alarm Mode Indicators:
1. The LED indicator will provide information on 7 modes of security system operation:
LED is off = Security system is disarmed.
LED is flashing = Security system is armed.
LED is flashing fast = Automatic arming timer or RF protection mode timer is counting down.
LED is on solid = Security system is in valet mode (only when the ignition key is on).
LED is flashing once every 5 seconds = Security system is in valet mode (Only when ignition key is off).
LED is flashing in a 2 flash-pause sequence = Tamper warning – security system has been trigger
from the hood/trunk switch or electronic sensor.
LED is flashing in a 3 flash-pause sequence = Tamper warning – security system has been triggered
from an opened door.
2. The horn/siren will provide information on the 4 modes of security system operation.
• One horn/siren chirp = Security system is armed.
• One horn/siren chirp + One more chirp 5 seconds after the first chirp = Security system is armed
but one of the sensors was on and the alarm has bypassed it. The remaining sensors are armed.
• Two horn/siren chirps = Security system is disarmed.
• Four horn/siren chirps = Tamper warning + security system is disarmed.
Remote Shock Sensor Delete:
As conditions require, you may want to delete the shock sensor function. To do this, press the LOCK button to
arm the system. Then press it a second time to delete the sensor function. You will then hear a second chirp
from the horn/siren.
Note: This is a one-time action. The next time the vehicle is armed the shock sensor function will be active.
PLUS-4800-UM.qxp 2/7/05 2:43 PM Page 5