User's Manual

9
Note: If you use password (see below Password Security) to double protect the vehicle security, you will
need to use it to completely disarm the system.
N. PASSWORD SECURITY :
In carry this feature you need to set features programming of password 'ON' first. Then program your
password number. Please see above PROGRAMMING section.
Using password to protect system. Below is an example of how to use password to completely
disarm system.
System in arm condition.
1. Open the door, siren will sound.
2. Turn ignition key on.
3. Push valet switch.
Note: When finished above procedures, system's siren stop alarming, parking light stop flashing, other
sensor stop trigger, but the vehicle can not be start and drive away.
Use password to cancel the system re-arm: ( Re-arm timer 30 seconds)
When system disarmed, the LED start flashing, indicate system entered password procedures.
Cancel system re-arm itself:
Wait until LED flash to your password number, then turn the ignition key 'on-off', to cancel re-arm.
You must make sure to turn the ignition key off at the correct number within 30 seconds. If not, the system
will automatically re-arm.
Example: To cancel re-arm using password number 5 of above, you would;
1. Open the door. Siren sound.
2. Turn ignition key on.
3. Push valet switch.
4. Wait LED flash 5 times, then quickly turn ignition key off.
Note 1: The number is form 1 through 10, by counting LED flash. Legal user can program the number.
Note 2: If some one turn the ignition key off at wrong override number, the system allows him to make 2
mistakes, if third time still wrong, it will automatically shut down for 3 minutes. During the period the system
will not accept any correct number, and when time is up it will re-armed again; which with siren one chirp
and parking light one flash, LED flashing, door locked and activate sensors to guard the vehicle.
O. IGNITION CONTROL POWER DOOR LOCK SAFETY SYSTEM :
The vehicle's doors will automatically lock after the ignition key turn 'on' (if all doors are closed.) And when
the ignition key turn 'Off', the doors will automatically unlock.
P. TRUNK RELEASE :
Press and hold button 2 on transmitter for two seconds to remote control the trunk release or other electric
devices.
Q. CHANNEL 3 CONTROL :
Press button 3 (designated channel setting), or button 1+3 together (auto channel setting) to remote control
the optional electrical device. The device will 'on' when the button(s) press continuously, and 'off' when the
button(s) released.
R. CAR LOCATOR :
Press button 2 twice (designated channel setting), or button 3 twice (auto channel setting) to active car
locator function. The siren will chirp 6 times. The parking light will flash 12 times, for you to easily locate
your car.
S. TRANSMITTER LOW BATTERY : (Random code transmitter only)
When the transmitter is in low battery condition, the system will show up by parking light flash 5 times, to
remind the user to change the low battery.
T. TWO STEPS DOOR UNLOCK :