User's Manual

2
Green Wire Negative Door Pin Switch:
Blue Wire: Instant Trigger Ground Input
Violet Wire: Positive Door Pin Switch
Oran
g
e Wire: 500mA Grounded when armed




+12V


N.O. circuit block
85 8630
87a
87
Cut
Black Wire: 500mA Grounded when disarmed
Red Wire:
(
-
)
200mA channel 4 out
p
ut
Gray Wire: (-) 200mA two step door unlock output
White Wire:
(
-
)
200mA horn out
p
ut
Pink Wire: (-) 200mA headlight output
Yellow Wire: (-) 200mA channel 3 output
Brown Wire:
(
-
)
200mA
p
a
g
er out
p
ut
+12V
85 8630
87a
87
Cut
N.C. circuit block
B. 2 PIN STARTER DISABLE PLUG:
This output can control starter disable, when an intrusion is detected and the system is triggered, the
vehicle is prevented from any unauthorized starting. Starter wires with 30 A relay built-in
C 4-PIN WHITE PLUG FOR ACCESSORY DETECTION DEVICES
4. + 12V
3. Negative
2. Ground Trig
g
1. Warn Away I
n
PROGRAMMING & ADJUSTMENT
A. PROGRAMMING TRANSMITTER:
Maximum is 4 transmitters. Two modes of programming, one is designated channel, (Button 1 is arm/disarm)
the other is auto channel setting. (Button 1 is arm, button 2 is disarm.)
1. Ent er:
Turn ignition to 'on' position. Within 15 seconds.
Push valet switch
3 times
to enter
designated
channel; if push
6 times
it will be
auto
channel.
1 long chirp to enter each channel's programming.
2. In designated channel:
In program 1
st
transmitter the LED will with one flash…pause sequence.
Press button 1 to program channel 1, 1 short chirp and LED on to confirm programmed and ready program
channel 2.
Press button 2 to program channel 2, 2 short chirps and LED on to confirm programmed and ready
program channel 3.
Press button 3 to program channel 3, 3 short chirps and LED on to confirm programmed and ready
program channel 4.
Press button 4 to program channel 4, 4 short chirps and LED on to confirm programmed
Program 2
nd
transmitter, push valet switch one time, the LED will with two flashes…pause sequence.
Press button 1 to program channel 1, 1 short chirp and LED on to confirm programmed and ready program
channel 2.
Press button 2 to program channel 2, 2 short chirps and LED on to confirm programmed and ready
program channel 3.