User's Manual
11
Totally after 90 seconds from beginning, siren still alarming and parking light still flashing, and the starter disable will
activate to prevent the vehicle from starting. Override the system to turn off car jacking. (Ignition from off to on, and within
10 seconds push valet switch)
N. IGNITION CONTROL POWER DOOR LOCK SAFETY SYSTEM.
The vehicle's doors will automatically lock after the ignition key turn 'on' (if all doors are closed.) And when the ignition key
turn 'Off', the doors will automatically unlock.
O. TRUNK RELEASE.
Press and hold button 2 on transmitter for two seconds to remote control the trunk release or other electric devices.
P. CHANNEL 3 CONTROL
Press button 3 (designated channel setting), or button 1+3 together (auto channel setting) to remote control the optional
electrical device. The device will 'on' when the button(s) press continuously, and 'off' when the button(s) released.
Q. CAR LOCATOR
Press button 4 will active car locator function. The siren will chirp 6 times. The parking light will flash 12 times, for you to
easily locate your car.
R. TRANSMITTER LOW BATTERY:
(Random code transmitter only)
When the transmitter is in low battery condition, the system will show up by parking light flash 5 times, to remind the user to
change the low battery.
S. PASSWORD SECURITY
In carry this feature you need to set features programming of password 'ON' first. Then program your password number.
Please see above PROGRAMMING section.
From arm to disarm:
1. Open the door, siren will sound.
2. Turn ignition key on.
3. Push valet switch.
Note: When finished above procedures, system's siren stop alarming, parking light stop flashing, other sensor stop trigger,
but the vehicle can not be start and drive away.
Use password to cancel the system re-arm: ( Re-arm timer 30 seconds)
When system disarmed, the LED start flashing, indicate system entered password procedures.
Cancel system re-arm itself:
Wait until LED flash to your password number, then turn the ignition key 'on-off', to cancel re-arm.
You must make sure to turn the ignition key off at the correct number within 30 seconds. If not, the system will automatically
re-arm.
Example: To cancel re-arm using password number 5 of above, you would;
1. Open the door. Siren sound.
2. Turn ignition key on.
3. Push valet switch.
4. Wait LED flash 5 times, then quickly turn ignition key off.
Note 1: The number is form 1 through 10, by counting LED flash. Legal user can program the number.
Note 2: If some one turn the ignition key off at wrong override number, the system allows him to make 2 mistakes, if third
time still wrong, it will automatically shut down for 3 minutes. During the period the system will not accept any correct
number, and when time is up it will re-armed again; which with siren one chirp and parking light one flash, LED flashing,
door locked and activate sensors to guard the vehicle.
T. SAFETY FEATURES:
If any of the following conditions exist while the system is operating, the engine will not start or will shut off immediately:
1. Hood is opened.
2. Brake pedal is pressed.
3. Engine exceeds 3 times the programmed idle speed.
4. Gear shift is in a position other than ‘PARK’ or ‘NEUTRAL’.
5. 10 minutes or 20 minutes time period runs out.
U. CONVENIENT FEATURES:
4 hours auto start: This feature is design for an extreme cold climate usage. The system will auto start the vehicle every 4
hours, to prevent engine freezing and hard to start.