User's Manual

10
Use in emergency, like lost or malfunctions of transmitter. Turn ignition on, within 10 seconds push the override/valet switch,
the siren will stop and the system disarmed.
2. VALET MODE:
Vehicle in for maintenance or valet parking, the system will not arm.
a. Turn ignition on then within 10 seconds push and hold override/valet switch for 2 seconds, the LED will turns on indicates
the system is in 'valet mode'.
b. System stay in 'valet mode', transmitter still can remote operating lock or unlock the doors, parking light, pop trunk
release and panic function. But no alarm function.
c. Return to normal operation, turn ignition 'on', then within 10 seconds, push and hold override/valet switch for 2 seconds, it
will exit the valet.
G. PASSIVE ARMING
It operate as below:
1. Turn 'off' the ignition.
2. Leave vehicle and close all doors.
3. LED fast flashing.
4 After 30 sec. System auto arming
Note: during the 30 sec. If open the door the time will stop counting down, until all doors closed then again re-start count
down for 30 sec.
Passive arming by-pass: Press button 2 twice (designated channel setting), to temporally by-pass passive arming.
That's for prevent locking yourself out of the vehicle (For example fill up the gas).
A short chirp will confirm this by-pass.
Re-open the door will not start the passive arming again.
Note: It’s only temporally by-pass. When turn ignition ‘on - off ‘ or use transmitter to arm or disarm, this by-pass will cancel.
H.ACTIVE ARMING:
1. Press arm button on transmitter.
2. The siren will chirp once after 3 seconds the system will be fully arm.
NOTE: Defective sensor reminder: 3 chirp indicate defective sensor occurred.
Special Note: If the system is interfacing with optional sensor, such as PIR or door/window sensor, upon system armed, if
the PIR or door sensor triggered, the system will full alarming.
I. ACTIVE DISARMING:
1. Press disarm button on the transmitter.
2. The siren will chirp twice to indicate that system disarmed.
NOTE: 1. Tamper disarming: If alarm triggered, upon disarm the system, siren chirp 4 times,parking light flash 3 times.
NOTE: 2. Automatic re-arm: No doors open and no ignition on after disarm; after 60 seconds system auto rearm.
J. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency. To do so, hold
button 1 for 3 seconds, and the system will full alarming. To stop panic, press button 1 again or press disarm button.
K. TRIGGER THE SYSTEM
While system in armed condition, open the doors, hood, trunk or trigger the optional sensors, siren and parking light will
turn on to alerting of an intrusion for 30 or 60 seconds. Then it will stop and automatic reset and re-arm. If the one of
sensors or detectors still active, the alarm system will sound a maximum of 3 times of 30 or 60 seconds cycles.
L. DOME LIGHT CONVENIENCE DELAY & SUPERVISION
Upon disarming, the dome lights will remain on for 30 seconds.
If the vehicle triggered, the dome light will flashing as the same duration as siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
M. ANTI CAR-JACKING
Warning: If you don't want to have car jacking in this alarm system, be sure to set car-jacking off. (See
programming features)
2-timer circuits will function as follows:
First timer:
60 seconds after the ignition is turned on, open the door then close the door, or press & hold transmitter's button 1 and 2
for 1 second. The siren will start alarming, and parking light will flashing. Within 30 seconds, you will be alert to turn the
ignition switch from off to on, and within 10 seconds push valet switch to turn off the car jacking feature. If not, it will enter
second timer car jacking.
Second timer: