User's Manual

Chapter 3 - Using the Web Configuration Server

Figure 53: Routing Table

Routing Table settings are used to setup the functions of static and

dynamic routing. The Routing Table window includes the following

parameters:

Table 38: Routing Table Parameters

Parameter Description

Dynamic Routing Routing Information Protocol (RIP) will exchange information

on destinations for computing routes throughout the network.

Select RIPv2 only if you have a different subnet on your

network. Otherwise, select RIPv1 if you need this protocol.

Static Routing For static routing, you can specify up to 8 routing rules. You

can enter the destination IP address, subnet mask, and

gateway, hop for each routing rule, and enable/disable the

individual rule.

Default Route Sets the default route interface as WAN or LAN. For LAN,

one IP for routing must be set.

Using the Web Configuration Server