User's Manual

Advanced Settings (Administrator only)
The SNMP Setting window includes the following parameters:
Table 37: SNMP Parameters
Parameter Description
Enable SNMP You must check either Local or Remote or both to enable the
SNMP function.
  Local - The device will respond to requests from LAN.
  Remote – The device will respond to requests from WAN.
Get Community Set the password for GetRequest access rights to your
device.
Set Community Setting the password for SetRequest access rights to your
device.
IP 1,IP 2,IP 3,IP 4 Enter your IP addresses for allowed managers. SNMP Trap
messages will be sent to this IP address as well. If no IP is
defined, the unit cannot be managed by any PC, from either
LAN or WAN.
SNMP Version Select the proper SNMP Version supported by your SNMP
Management software.
In the above figure:
  The device will respond to requests from both LAN and WAN.
  The device will respond to SNMP clients whose get community is set as
"public" and coming from IP 192.168.123.33.
  The device will respond to SNMP clients whose set community is set as
"private" and coming from IP 192.168.123.33.
  This device will send SNMP Trap messages to 192.168.123.33 (Using
SNMP Version V2c).
3.9 .5 Routing Table
Routing allows to determine which physical interface address to use for
outgoing IP data grams. If you have more than one gateway and subnet,
you will need to enable Routing Table to allow packets to find the proper
routing path and allow different subnets to communicate with each other.
NG System Manual
77