User's Manual Part 2

Chapter 錯誤! 尚未定義樣式。 - 錯誤! 尚未定義樣式。
錯誤! 尚未定義樣式。
3-46
 Get Date and Time by NTP Protocol - Select if you want to set the
device's internal clock using the Network Time Protocol (NTP).
¾ Time Server - Select an NTP time server to consult UTC time.
¾ Time Zone - Select a time zone where this device is located.
¾ Sync Now! - Synchronize system time with network time
server (alternatively, synchronization will be performed
automatically from time to time).
 Set Date and Time using PC's Date and Time – Select if you want
the device's internal clock to synchronize with the PC's clock.
 Set Date and Time manually - Select if you want to manually set the
device's internal clock. You need to specify:
¾ Date: Year, Month, Day
¾ Time: Hours (0-23), Minutes (0-59), Seconds (0-59).
¾ TBD – The clock is set upon clicking Save.
NOTE
The device time is displayed at the bottom of the Status window.
In addition, you can specify daylight saving time as follows:
 Daylight Saving - Enable/disable Daylight Saving and set start and
end time of daylight saving time range.
System Log
System Log enables to set parameters for exporting system logs to a
specified destination. Two exporting methods are supported: syslog
(UDP) and SMTP (TCP).
刪除: 3
刪除: 3
刪除: Operation and
Administration
刪除: Operation and
Administration