User's Manual Part 2

錯誤! 尚未定義樣式。
Wireless Networking Gateway System Manual
C-5
Figure 62: Smart Card or Certificate Properties
4. Change EAP type to fit the variable test condition.
 Windows 2000 RADIUS server Authentication testing:
¾ DUT authenticate PC1 using certificate. (PC2 follows the
same test procedures.)
5. Download and install the certificate on PC1. (Fig 4)
6. PC1 choose the SSID of DUT as the Access Point.
7. Set authentication type of wireless client and RADIUS
server both to EAP_TLS.
8. Disable the wireless connection and enable again.
9. The DUT will send the user's certificate to the RADIUS
server, and then
10. send the message of authentication result to PC1. (Fig 5)
11. Windows XP will prompt that the authentication process
is success or fail and end the authentication procedure.
(Fig 6)
12. Terminate the test steps when PC1 get dynamic IP and
PING remote host successfully.
刪除: Set TCP/IP Protocol
for Working with NAT
Router
刪除: Wizard