User's Manual Part 1

Chapter 錯誤! 尚未定義樣式。 - 錯誤! 尚未定義樣式。
錯誤! 尚未定義樣式。
3-20
¾ Connect-on-demand – An IP address is automatically
allocated whenever the user attempts to make a connection.
¾ Auto reconnect(Always-on) – The system automatically
connects to the ISP after restart or after connection is
dropped.
¾ Manually – The user manually performs the connection.
LAN Setup
Select Basic Setting > LAN Setup submenu on the menu list. The LAN
Setup window opens.
Figure 18: LAN Setup
Enter the following parameters:
 LAN IP Address – Sets the local IP address of the device. The users
on your network must use this LAN IP address as their default
gateway. You can change it as necessary.
 LAN Subnet Mask – Sets the subnet mask to the LAN IP address.
 DHCP Server – Enable/Disable to turn off this service. When
enabled, the LAN Setup window display changes (indicated by the
red icon), and the following parameters are displayed (see Figure 19):
¾ Range of IP addresses Pool – Specify the starting and ending
address for DHCP clients.
¾ Domain suffix – Specify the domain suffix for DHCP clients.
刪除: 3
刪除: 3
刪除: Operation and
Administration
刪除: Authentication for IP
allocation. Select one of the
following options:
<#>Connect-on-demand –
An IP address is
automatically allocated
whenever the user attempts
to make a connection.
<#>Auto reconnect(Always-
on) – The system
automatically connects to
the ISP after restart or after
connection is dropped.
Manually – The user
manually performs the
connection.
刪除: Operation and
Administration