User's Manual Part 1

錯誤! 尚未定義樣式。
Wireless Networking Gateway System Manual
3-17
PPP over Ethernet
Some ISPs require the use of PPPoE to connect to their services. If this
is the case, click Change to select PPPoE as your WAN type. The
Primary Setup window display changes to reflect the parameters for
PPPoE.
Figure 16: Primary Setup - PPPoE
 PPPoE Account – The account assigned to you by your ISP.
 PPPoE Password: the password assigned to you by your ISP. This
field appears blank. If you don't want to change the password, leave
it empty.
 Primary DNS – The DNS provided by your ISP. To use a specific DNS,
enter a specific address (optional).
 Secondary DNS – The backup DNS provided by your ISP. (optional)
 Maximum Idle Time - The amount of time of inactivity before
disconnecting your PPPoE session. To disable this feature, set this
parameter to 0 seconds, or enable Auto-reconnect.
 Connection Control – Authentication for IP allocation. Select one of
the following options:
¾ Connect-on-demand – An IP address is automatically
allocated whenever the user attempts to make a connection.
¾ Auto reconnect(Always-on) – The system automatically
connects to the ISP after restart or after connection is
dropped.
刪除: Set TCP/IP Protocol
for Working with NAT
Router
刪除: Wizard