User Manual

3.2.3.4 MAC Control
MAC Address Control allows you to assign different access right for different users and to assign a specific
IP address to a certain MAC address.
1. MAC Address Control
Check “Enable” to enable the “MAC Address Control”. All of the settings in this page will take
effect only when “Enable” is checked.
2. Connection control
Check "Connection control" to enable the controlling of which wired and wireless clients can
connect to this device. If a client is denied to connect to this device, it means the client can't access
to the Internet either. Choose "allow" or "deny" to allow or deny the clients, whose MAC
addresses are not in the "Control table" (please see below), to connect to this device.
3. Association control
Check "Association control" to enable the controlling of which wireless client can associate to the
wireless LAN. If a client is denied to associate to the wireless LAN, it means the client can't send
or receive any data via this device. Choose "allow" or "deny" to allow or deny the clients, whose
MAC addresses are not in the "Control table", to associate to the wireless LAN
Click on “Save” to store what you just select or “Undo” to give up
Click on “Next Page” to go down or “Previous page” back to last page
註解 [023]: 刪除逗點且應該
為小寫 choose
註解 [024]: 應改為
controllable