User's Manual

3. Primary DNS/Secondary DNS: Optional, This feature allows you to assign a DNS Servers

4. Connection Control: There are 3 modes to select:

Connect-on-demand: The device will link up with ISP when the clients send outgoing

packets.

Auto Reconnect (Always-on): The device will link with ISP until the connection is

established.

Manually: The device will not make the link until someone clicks the

Connect-button in the Status-page.

5. Maximum Idle Time: the amount of time of inactivity before disconnecting your PPPoE

session. Set it to zero or enable “Auto-reconnect＂ to disable this feature.

6. Service Name: optional. Input the service name if your ISP requires it. Otherwise, leave it

blank.

7. Assigned IP Address: Optional, Input the IP address you want. Usually, leave it blank.

8. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default

MTU value is 0(auto).

9. NAT disable: the option bridges data form WAN port to LAN port.

H. Wi-Fi HotSpot

Wi-Fi HotSpot Types: This WAN type allows you to share one Wi-Fi Hotspot account with your

friends or colleagues. Local clients connect to this device via Wi-Fi connection, and surfing

Internet by connecting to remote Wi-Fi Hotspot. Just follow a few steps below to connect to remote

Wi-Fi HotSpot.

Note. If choosing Wi-Fi HotSpot WAN type, the wireless channel of WLAN will be set to as same

as wireless channel of remote Wi-Fi HotSpot.

Step 1: Click “Wi-Fi HotSpot” Search” button to search any available Wi-Fi Hotspot or Wi-Fi AP

(Access Point) in your environment.