User's Manual

26
7. Maximum Idle Time: The time of no activity to disconnect your L2TP session. Set it to
zero or enable “Auto-reconnect” to disable this feature. If Auto-reconnect is enabled, this
device will connect with ISP automatically, after system is restarted or connection is
dropped.
8. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send
outgoing packets.
Auto Reconnect (Always-on): The device will link with ISP until the connection is
established.
Manually: The device will not make the link until someone clicks the
connect-button in the Status-page.
9. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default
MTU value is 0 (auto).
G. iBurst
iBurst Type: The WAN fields may not be necessary for your connection. The information on this
page will only be used when your service provider requires you to enter a User Name and
Password to connect with the iBurst network.
Please refer to your documentation or service provider for additional information.
1. Account: Enter the new User Name for your PC card here, you can contact to your ISP to
get it.
2. Password: Enter the new Password for your PC card here, you can contact to your ISP to
get it.