User Manual

25
C. PPP over Ethernet
1. Activate WWAN for Auto-Failover: With this function enabled, when the
Ethernet WAN connection is broken, the device will automatically activate the
WWAN connection and keep you connected to internet with the alternative
WWAN broadband service. Meanwhile, if the device detected that the Ethernet
WAN connection is recovered, your broadband connection will be switched to use
the Ethernet WAN service.
2. PPPoE Account and Password: The account and password your ISP assigned
to you. For security, this field appears blank. If you don't want to change the
password, leave it blank.
3. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send
outgoing
packets.
Auto Reconnect (Always-on): The device will link with ISP until the
connection is
established.
Manually: The device will not make the link until someone clicks the
connect-button in
the Status-page.
4. Maximum Idle Time: the amount of time of inactivity before disconnecting your
PPPoE session. Set it to zero or enable “Auto-reconnect” to disable this