User's Manual Part 1

26
E. PPP over Ethernet
1. WAN Type: Choose PPP over Ethernet.
2. IPv6 Dual Stack: If your ISP supports IPv6 dual stack, you can check this check box to
get an IPv4 address and an IPv6 address via one PPPoE connection. After you check this
check box, you also need to enable IPv6 function at Advanced Setting->IPv6 setting
page.
3. PPPoE Account and Password: The account and password your ISP assigned to you.
4. Primary DNS: You can indicate IP address of primary DNS if required.
5. Secondary DNS: You can indicate IP address of secondary DNS if required.
6. Connection Control: There are 3 options to start connection:
 Auto Reconnect (Always-on): The device will always try to link to Internet.
 Connect-on-demand: The device won’t try to connect to Internet until LAN PCs or
devices try to go to Internet. Once Internet connection is established, this device will
drop the connection if maximum idle time is reached.
 Manually: The device won’t try to connect to Internet until users press “connect”
button at Status page. Once Internet connection is established, this device will drop
the connection if maximum idle time is reached.
7. Maximum Idle Time: the amount of time of inactivity before disconnecting your PPPoE
session. Set it to zero or enable “Auto-reconnect＂ to disable this feature.