User's Manual

the led is light?

A: First, please check Status Led. If the device is normal, the led will blink per second.

If not, please check How blinking Status led shows.

There are many abnormal symptoms as below:

Status Led is bright or dark in work: The system hanged up .Suggest powering off and on

the router. But this symptom often occurs, please reset to default or upgrade latest fw to try

again.

Status led flashes irregularly: Maybe the root cause is Flash rom and please press reset

Button to reset to default or try to use Recovery mode.(Refer to Q3 and Q4)

Status flashes very fast while powering on: Maybe the router is the recovery mode and

please refer to Q4.

3.How to reset to factory default?

A: There are 2 methods to reset to default.

Restore with RESET button

First, turn off the router and press the RESET button in. And then, power on the router and push the

RESET button down until the M1 and or M2 LED (or Status LED) start flashing, then remove the

finger. If LED flashes about 8 times, the RESTORE process is completed. However, if LED flashes 2

times, repeat.

2. Restore directly when the router power on

First, push the RESET button about 5 seconds (Status will start flashing about 5 times), remove the

finger. The RESTORE process is completed.

4.How to do recovery mode when the router is abnormal ?

A: Allocate a Static IP Address on your computer as below:

Step1:First, press the reset button and power on the router until Status blinks very ffast.

Step2:Find the Inter Protocol(TCP/IP) Properties from My Network Places and check Properties

of Local Area Network Connection. And click the “General” icon and assign one IP address

which can be from 192.168.123.1 to 192.168.123.253. Here we use the 192.168.123.88 as

the IP address. The Subnet mask must be 255.255.255.0, and the Default gateway must

be 192.168.123.254. Then click “OK” button to complete TCP/IP setup.