User's Manual

correctly.

Ensure that your Ethernet Adapter is working, and that all network drivers are installed

properly. Network adapter names will vary depending on your specific adapter. The

installation steps listed below are applicable for all network adapters.

1. Go to Start > Right click on “My Computer” > Properties.

2. Select the Hardware Tab.

3. Click Device Manager.

4. Double-click on “Network Adapters”.

5. Right-click on Wireless Card bus Adapter or your specific network adapter.

6. Select Properties to ensure that all drivers are installed properly.

7. Look under Device Status to see if the device is working properly.

8. Click “OK”.

2 What can I do if my Ethernet connection does not

work properly?

A. Make sure the RJ45 cable connects with the router.

B. Ensure that the setting on your Network Interface Card adapter is “Enabled”.

C. If settings are correct, ensure that you are not using a crossover Ethernet cable, not

all Network Interface Cards are MDI/MDIX compatible, and use a patch cable is

recommended.

D. If the connection still doesn’t work properly, then you can reset it to default.