User's Manual

Note: It is recommended that you use an

4 . Troubleshooting

This Chapter provides solutions to problems for the installation and operation of the WiFi

Broadband Router. You can refer to the following if you are having problems.

1 Why can’t I configure the router even the cable is

plugged and the LED is lit?

Do a Ping test to make sure that the WiFi

Broadband Router is responding.

Go to Start > Run.

1. Type cmd.

2. Press OK.

3. Type ipconfig to get the IP of default gateway.

4. Type “ping 192.168.123.254”. Assure that you ping the correct IP Address

assigned to the WiFi Broadband Router. It will show four replies if you ping