User's Manual

66
1. Enable SNMP: You must check “Local”, “Remote” or both to enable SNMP function. If
“Local” is checked, this device will respond request from LAN. If “Remote” is checked,
this device will respond request from WAN.
2. Get Community: The community of GetRequest is that this device will respond.
3. Set Community: The community of SetRequest is that this device will accept.
4. IP 1, IP 2, IP 3, IP 4: Enter the IP addresses of your SNMP Management PCs. User
has to configure where this device should send SNMP Trap message.
5. SNMP Version: Select proper SNMP Version that your SNMP Management software
supports.
6. WAN Access IP Address: If you want to limit the remote SNMP access to specific
computer, please enter the PC’s IP address. The default value is 0.0.0.0, and it means
that any Internet connected computer can get some information of the device with
SNMP protocol.
Afterwards, click on “Save” to store your settings or click “Undo” to give up the changes.
3.2.4.2. TR-069