User's Manual

Ethernet WAN

A. Dynamic IP Address

1. Activate WWAN for Auto-Failover: With this function enabled, when the

Ethernet WAN connection is broken, the device will automatically activate the

WWAN connection and keep you connected to internet with the alternative

WWAN broadband service. Meanwhile, if the device detected that the

Ethernet WAN connection is recovered, your broadband connection will be

switched to use the Ethernet WAN service.

2. Host Name: Optional, required by some ISPs, for example, @Home.

3. ISP registered MAC Address: Enter MAC address of your ISP. (Optional)

4. Connection Control: Connect-on-demand is the device will link up with ISP

when the clients send outgoing packets. Auto Reconnect (Always-on) is the

device will link with ISP until the connection is established. Manually mode is

the device will not make the link until someone clicks the connect-button in the

Status-page.

5. NATdisable : If you enable this option, it will act with a non-NAT function.

6. Multicast : you may enable as auto mode or select by IGMP v1, IGMP v2,

IGMP v3.