User's Manual

Manually: The device will not make the link until someone clicks the

connect-button in the Status-page.

4. Maximum Idle Time: the amount of time of inactivity before disconnecting your

PPPoE session. Set it to zero or enable “Auto-reconnect＂ to disable this

feature.

5. PPPoE Service Name: Optional. Input the service name if your ISP requires it.

Otherwise, leave it blank.

6. Assigned IP Address: It is required by some ISPs. (Optional)

7. Maximum Transmission Unit (MTU):

Most ISP offers MTU value to users. The

default MTU value is 0 (auto).

8. NAT disable: The device would not send private IP to other LAN PC if you select

disable.