User's Manual
WiFiBroadbandBG
BDE761AM-001 User Manual 62
1. Dynamic Routing: Routing Information Protocol (RIP) will exchange information
about destinations for computing routes throughout the network. Please select
RIPv2 only if you have different subnets in your network. Otherwise, please
select RIPv1 if you need this protocol.
When you finished setting, click on “Save” to store your settings or click “Undo”
to give up the changes.
2. OSPF: OSPF is an interior gateway protocol that routes Internet Protocol (IP)
packets solely within a single routing domain (autonomous system). It gathers
link state information from available routers and constructs a topology map of the
network. The topology determines the routing table presented to the Internet
Layer which makes routing decisions based solely on the destination IP address
found in IP packets.
You can enable the OSPF routing function by click on the “Setting” button and fill
in the corresponding setting for your OSPF routing configuration. When you
finished setting, click on “Save” to store your settings or click “Undo” to give up