User's Manual

WiFiBroadbandBG
BDE761AM-001 User Manual   49
2. Green AP: Enable the Green AP function to reduce the power consumption
when there is no wireless traffics.
3. Channel: The radio channel number. The permissible channels depend on the
Regulatory Domain. The factory default setting is auto channel selection.
4. Authentication & Encryption: You may select one of the following
authentications to secure your wireless network: Open, Shared, Auto, WPA-PSK,
WPA, WPA2-PSK, WPA2, WPA-PSK/WPA2-PSK, or WPA /WPA2.
5. Remote AP MAC 1 ~ Remote AP MAC 4: If you do not enable the Lazy mode,
you have to enter the wireless MAC address for each WDS peer one by one.
Afterwards, click on “Save” to store your settings or click “Undo” to give up the
changes.
3.1.3.2 Advanced Wireless Setup
This device provides advanced wireless setup for professional user to optimize the
wireless performance under the specific installation environment.
1. Beacon interval: Beacons are packets sent by a wireless router to synchronize
wireless devices.
2. Transmit Power: Normally the wireless transmission power operates at 100%
out power specification of this device. You can lower down the power ratio to
prevent transmissions from reaching beyond your corporate/home office or
designated wireless area.
3. RTS Threshold: If an excessive number of wireless packet collision occurred,
the wireless performance will be affected. It can be improved by adjusting the