User's Manual
WiFiBroadbandBG
BDE761AM-001 User Manual 47
1. Lazy Mode: This device support the Lazy Mode to automatically learn the MAC
address of WDS peers, you don’t have to input other peer AP's MAC address.
However, not all the APs can be set to enable the Lazy mode simultaneously; at
least there must be one AP with all the WDS peers’ MAC address filled.
2. Green AP: Enable the Green AP function to reduce the power consumption
when there is no wireless traffics.
3. Wireless Schedule: The wireless radio can be turn off according to the schedule
rule you specified. By default, the wireless radio is always turned on when the
wireless module is enabled.
4. Network ID (SSID): Network ID is used for identifying the Wireless LAN (WLAN).
Client stations can roam freely over this device and other Access Points that
have the same Network ID. (The factory default setting is “default”)
5. SSID Broadcast: The device will broadcast beacons that have some information,
including SSID so that wireless clients can know how many AP devices by
scanning the network. Therefore, if this setting is configured as “Disable”, the
wireless clients can not find the device from beacons.
6. WLAN Partition: You can check the WLAN Partition function to separate the
wireless clients. The wireless clients can’t communicate each other, but they can
access the internet and other Ethernet LAN devices.
7. Channel: The radio channel number. The permissible channels depend on the
Regulatory Domain. The factory default setting is auto channel selection.
8. Authentication & Encryption: You may select one of the following
authentications to secure your wireless network: Open, Shared, Auto, WPA-PSK,
WPA, WPA2-PSK, WPA2, WPA-PSK/WPA2-PSK, or WPA /WPA2.