Owner's manual
ADVANCE ADAPTERS INC. P/N: 50-0210
P.O. Box 247, 4320 Aerotech Center Way New Item: (08/94)
Paso Robles, CA 93447 PAGE 1 OF 4
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 02-19-02
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components
will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly
recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We
recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally
available at automotive dealerships and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
1. 1 51-0212 ADAPTER CASTING 5.875" LONG
2. 1 52-0210 6 SPLINE SPUD SHAFT (31T INTERNAL)
3. 1 716144 SPECIAL BEARING RETAINER FOR JEEP (Large Hole)
4. 1 716302 SEALED BEARING
5. 1 716455 SNAP RING
6. 1 716462 SET COLLAR
7. 1 716568 GASKET
8. 1 716721 NATIONAL SEAL #3095
9. 1 728701 NYLON NUT
10. 1 JP001 JEEP INSTRUCTION MANUAL
11. 1 NV001 NEW VENTURE INSTRUCTION MANUAL
NEW VENTURE MODEL 4500 5 SPEED
TO JEEP DANA 20 6 SPLINE T/C
NOTE:
This adapter kit has an overall transmission assembled length of 18.250". This transmission kit must be used with a 4WD
GM transmission.
The length of this adapter will make it nearly impossible to use this transmission with the CJ5 models. The only exception
would be a 4 cylinder engine or V6 engine that is set to the very forward position of the engine compartment. It would
not be recommended to have a suspension lift, since the rear driveline angle would not be compatible. Due to the size
of the transmission, a body lift would be almost mandatory. We prefer that these adapters only be used in the CJ7 vehicles
or wagons and trucks.
SPECIAL NOTE:
The output gear and nut assembly must use original 7/8" washer to secure gear properly.