Owner manual

SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the
components will void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion,
we strongly recommend that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter
components. We recommend that a service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment.
These manuals are normally available at automotive dealerships and parts stores.
KIT CONSISTS OF:
No. Qty Part No. Description
ADVANCE ADAPTERS INC. P/N: 27-0000T
P.O. Box 247, 4320 Aerotech Center Way
Paso Robles, CA 93447 PAGE 1 OF 1
Telephone: [phone] Fax: [phone] Page Rev. Date: 09-27-02
DANA 300/CHEVY V8 TRANS. KIT
1. 1 Kit 712550 DODGE NV4500 x GM 5.125 DIA. BHSG.
2. 1 Kit 716021 DANA 300 CROSSMEMBER MOUNT
3. 1 Kit 716048 DANA 300 CROSSMEMBER SPACER
4. 1 Kit 716050D1 NV4500 SHIFT HANDLE ASSY
5. 1 Kit 716221 DANA300/NV4500 RETAINER KIT
6. 1 Kit 716638 JEEP CLUTCH PIVOT-GM V8
7. 1 Kit 52-0229 29 SPLINE INPUT GEAR
8. NV4500 OUTPUT SHAFT-MUST BE SHORTENED
INSTALLATION NOTES:
This kit is designed to fit the 29 spline Dodge Standard Duty NV4500 transmission.
This kit requires the use of a stock GM bellhousing with a 5.125" index diameter.
This is a parts pull sheet. Refer to the instruction sheet on each kit for proper installation.
SPECIAL INSTRUCTIONS:
When assembling the transmission to the transfer case, DO NOT FORCE the two gear boxes together. The output
shaft of the NV4500 must be shortened .250" to eliminate the possibility of pre-loading the transmission bearings for
premature failure. Take the extra time to make sure that the shafts do not bottom out internally.


