operation manual

6
3.4 Mounting
NOTE: If mounting at a later time, the 24 Volt plug must not be connected to the ceiling box when
mounting the receiver part in the ceiling box.
The lid on the black ceiling box is ”clicked” off by using a screwdriver (picture 1) and the white wire is
dismounted in the screw terminals 1, 2 and 3 (picture 2). The wires from the receiver “lid” are attached
to the terminals and the screws are tightened lightly (picture 3).
The lid is ”clicked” on and the 24 Volt plug is placed in the ceiling box. The LED’s light is red with a
green flash once every second, is a sign that the unit works correctly.
3.5 Pairing of sender and receiver
Hold the sender unit in the hand and activate the pairing by pushing the switch in the middle of the lid.
If necessary, use a pen for it. The LED’s light remains red, but it will flash green three times per
second for 30 seconds.
The pairing with the sender happens by pushing the Start / Boost button within 30 seconds.
When it’s paired, the DraftOptimizer starts by ”boosting”, and the LED’s light remains red with a green
flash once every second.
The sender and the receiver are now paired and the DraftOptimizer is ready to use.
Notice: The sender’s reach is up to 70 metres. Walls, metal screens, radio signals etc. can reduce or
disrupt the reach of the sender.
3.6 Warranty
There is a 2 years’ warranty if manufacturing or construction defects occur.
3.7 Specifications
Model
Aduro DraftOptimizer BC/RC
Sender
433 MHz
Battery
12 VDC
Reach
Up to 70 m.
Picture 1
Picture 2
Picture 3