User Manual

The frontpage of the app shows:

1. Power status

2. Heat level

3. Smoke temperature

4. CO level (Safety measurement which measures whether there is smoke in the back of the system).

A green bar is OK. If the bar reaches yellow, the hybrid stove will lower its heat level to 1. If the bar

reaches red, the stove will turn off itself.

The CO sensor is located by the pellet inlet to prevent the stove from firing when the chimney draft is not

sufficient. The CO sensor could be affected by the pellets. Some pellet bags have a high level of CO that can

affect the sensor up to 24 hours after loading the stove with pellets. If this problem occurs, you can open the

door to the pellet container and add fresh air to the room until the CO level has dropped.

2.5.1 How to connect the stove to the internet

For successful connection, there must be a stable Wi-Fi signal where the stove is installed. In case of weak

or unstable signal, the use of the stove could be affected.

It is recommended to install the stove where there is a maximum Wi-Fi signal with 3 out of 3 or 4 out of

4 . Your smartphone/tablet must be connected to the local Wi-Fi network. If you experience any

difficulties controlling the stove via the smartphone/tablet, it is due to the fact that the smartphone/tablet has

a control system that does not meet our requirements (See 2.5). If you are able to control the stove through

the smartphone/tablet but can’t connect the stove to the Wi-Fi router, the router is too old and/or the signal

too weak. If this is the case, we recommend you to buy a new router with a strong signal and a Wi-Fi

amplifier that is located somewhere between the router and the stove.

If other electronic devices work well in the house, but the hybrid stove can’t be connected, it is due to the fact

that the hybrid stove requires a stronger Wi-Fi signal than other electronic devices.

2.6 Electrical connection

Aduro H2 comes with approx. 1.5 meter of cord with an Euro-plug, that should be connected to a 230V /

50Hz outlet. Power consumption during operation is approx. 33 watts. The cord must be positioned so it is

not in contact with hot surfaces or pointed objects.

2.7 Register your stove on Aduro Cloud

We highly recommend that you register your hybrid stove on our cloud www.adurocloud.com as soon as the

stove is connected to your Wi-Fi router. By registering your stove, you will have access and overview of your

stove’s data – what it does, how it burns (graphs, statistics, logs, settings) etc. When your stove is registered,

At our website you can find more information on how to configurate the Wi-Fi.

Go to https://www.adurofire.com/aduro-hybrid/ under “Frequently asked questions”

and “Wi-Fi connection”.