User Manual

70
Brazier
We recommend two types of maintenance during the week: a short cleaning while the stove is lit (cannot last
more than 3 minutes because of the sensor in the door) and a thorough cleaning where the stove is turned
off and cold. We recommend that you conduct the short cleaning 2 times a day and the thorough cleaning
every 4 days.
During the short cleaning, the stove must be cleaned under the brazier. We recommend that you use gloves.
By using a tong or a similar tool, you can move the brazier to the side and clean out ash and cinders. Put the
brazier back in place. During the thorough cleaning, the fireproof tiles must be removed, and the auger and
the combustion chamber must be vacuumed thoroughly.
6.2 Regularly maintenance – when needed
Ashes
Empty the ashpan before it gets completely full. Always leave a layer of ashes in the stove because it
insulates and makes it easier to light a fire.
Remove the brazier and clean the top auger for ashes with a vacuum cleaner. This is done easiest by
making a "paper ring" of paper roll, which is laid around the opening of the auger. Then press the vacuum
cleaner muzzle down towards the "paper ring" so it fits tightly. After this, the ashes can be vacuumed up.
Glass
Wet wood, insufficient chimney draft, and wrong use of the hybrid stove can leave soot stains on the glass.
They can easily be removed using a damp cloth that you dip in cold ash and rub on the sooty glass. Special
cleaning agents are also available to remove soot from glass, e.g. the Aduro Easy Clean pad. The pad
neither scratches nor damages the glass, and it can be used multiple times. Water or other cleaning agents
are not necessary.
It is common maintenance to tighten the glass fittings and the hinges shortly after the stove has been
installed as well as to check if the gaskets are properly placed.
Pellet container
Burn all pellets and brush the container clean.
6.3 Periodically maintenance – after about 500 hours of use
If the stove is placed in dusty surroundings, it can be necessary to clean the ventilator. Clean the brazier for
ash and cinders, e.g. with a scraper. Clean the air pathway for electrical igniter for ash and cinders that might
be covering the hole placed on the left side of the tube under the brazier, e.g. using a small, straight
screwdriver.
For further information regarding maintenance of the stove, please go to www.adurofire.com.
6.4 Yearly maintenance
The yearly maintenance must be conducted by a professional. Contact your local Aduro GO partner for
further information as rules for chimney sweeping and stove maintenance differ from area to area.