User Manual

63
3.3.4 Lighting the fire with pellets
Before the pellet function of the stove is turned on, you should ensure that there are enough pellets
underneath the brazier. You can do this by moving the brazier to the side. If there are pellets up to around 1
cm under the edge of the auger tube, there are enough pellets. You can now put the brazier back in place.
Remember to check that it is placed correctly and fits tightly. Then, you can turn on the stove.
Push the ON/OFF button and wait until the ON button displays a constant green colour. The lighting of the
fire will then start automatically, and the pellet burner will start. When the stove is lighting, the combustion
chamber will be filled with smoke until the ignition starts. After approx. 6 minutes flames should appear.
Normal use should be achieved after 15-20 minutes.
When the smoke temperature reaches 90 degrees, the stove will shift from the “warm up mode” to “normal
mode” and continue with the last settings. You can manually change between 3 heat levels without using the
app by pushing the logo with an auger, which is placed directly under the ON/OFF button on the display.
• Step 3 (100 % operation): ‘ON button’ lights green constantly.
• Step 2 (50 % operation): ‘ON button’ flashes quickly.
• Step 1 (10 % operation): ‘ON button’ flashes slowly.
When you want to switch of the pellet burner, push the ON/OFF button or use the app.
If you experience that the stove does not turn on in the first or second attempt but instead shows the alarm
“ignition failed”, it is important that you do not try to turn on the stove again. Instead, wait until there is no
more smoke in the combustion chamber, and then move the brazier to the side and scrape the pellets away
if they have accumulated. You can now put the brazier back in place. Remember to check if it is placed
correctly. Then, you can turn on the stove again. The alarm “ignition failed” is often caused by an insufficient
chimney draft. You can create chimney draft by igniting some paper or small pieces of firewood - this can
sometimes remove pockets of air in the chimney.
The pellet function can burn up to 24 hours on a full pellet container at level 1, 12 hours at level 2, and 8
hours at level 3. The stove is capable of running day and night, if pellets are added in time.
3.3.5 Lighting the fire with wood and pellets at the same time
Cold stove
Put dry wood in the combustion chamber - just as if you wanted to start the stove manually (see section
3.3.1). However, you won’t need any firelighters. The fire is lid with pellets. It will be an advantage, if you
start with a closed air inlet until the fire is burning in the pellet burner. After this, you can open the air inlet for
Brazier