User's Manual

has adequate available space.
Installation Instructions:
Read these instructions in their entirety before
performing any installation work.
2. Remove the existing wallplate from the wall
switch location.
3. Unscrew the wall switches and pull forward.
Before loosening the wires, verify that power
circuit breaker.
4. Remove both switches for bi-level switching
applications.
5. Using a wire nut sized for the application,
connect the hot conductor, all switched legs
and the black wire on the Wall Control Interface.
Verify that all wires are secured by the wire nut.
6. Connect the green wire on the Wall Control
Interface to the ground wire in the junction box.
If no ground wire is present, then attach the
green wire to the junction box with a ground
screw.
7. Connect the 3 low voltage conductors to a UL
listed low voltage wall switch (for example,
Leviton® model 56081-2).
•The low voltage gray conductor on the Wall
Control Interface connects to the common of
the wall switch.
•The low voltage blue conductor attaches to the
on terminal of the wall switch.
•The low voltage yellow conductor attaches to
8. Install the wall switch on the desired side of the
double gang opening. Secure the wall switch
with screws to the holes provided for device
mounting. Secure the Wall Control Interface in
the other opening with screws to the holes
provided for device mounting.
9. Attach a new wallplate with one side blank (For
example, Leviton® model 80708 or 80607-W for a
two gang switch box).
ADURA TECHNOLOGIES™
San Francisco, CA 94105
Tel: [phone] • Toll Free 1-888-828-8281
TM
Wiring Diagram
Dimensions:
1 1/2”
2 1/2”
1"
1
1/8”
There is a 30 second warm-up period when
If you encounter a situation other than described
below, please contact Adura Technologies for
technical support.
Wall
Switch
GRAY
(COMMON)
GREEN
120 OR
277 VAC
GROUND
LOAD
LINE
BLACK
BLUE
(TOP PRESS ON SWITCH)
YELLOW
(BOTTOM PRESS ON SWITCH)
LOW
VOLTAGE
GREEN
BLACK
BLACK
{
Wall Control Interface
Decorator Opening
Desired wallplate size/design
must be purchased separately.
WCI available individually or in a kit
momentary toggle switch.
WCI mounts in a double
gang switch box alongside
a low voltage switch.