Installation Manual

To install the Light Controller take the
following steps:
1. Turn off all power to the light fixtures by
switching off the circuit breaker or other
disconnect.
2. Open the fixture cover and remove the
cover for the ballast cavity. The ballast
and its wiring should now be visible.
(See Figure #1)
3. With a volt meter, verify that power is
off to the light fixture.
4. Place Light Controller in the desired
location and secure with the magnets
on the rear of the Light Controller or
screw it down.
6. Connect the black wire on the Light
Controller wires to the hot wire (black
for 120 V or brown for 277 V) using a
wiring connector (see wiring diagram #1
for one relay and wiring diagram #2 for
two relays).
7. Connect the blue wire on the Light
Controller to the black wire on the
ballast using a wiring connector.
8. Connect the white wire on the Light
Controller to the white wire on the
ballast and to the white wire on the
incoming power wiring using a wiring
connector.
9. Bend wires into place such that ballast
cover can easily be reattached.
10.Reattach the ballast cover and close
the luminaire cover.
11. Switch power on to the fixture.
Lights should turn on.
12.Refer to the setup application instruc-
tions for information on programming
the light controller.
Dimming Control (LC-1RD)
(See wiring diagram #3)
CAUTION: LOW VOLTAGE WIRING
MUST BE TREATED AS CLASS 1
1. Connect the gray wire on the LC-1RD
to the gray wire or gray terminal on the
dimming ballast.
2. Connect the violet wire on the LC-1RD
to the violet wire or violet terminal on
the dimming ballast.
3. When switched on, lamps should turn
on to full brightness. (Approximately
10 VDC signal on the Violet wire to
ground).
Dimensions:
6 11/16”
7 5/8”
1”
1 3/16”
7 1/4”
WiringDiagram#1
LC-1R
120 VAC /277 VAC
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
BALLAST
H
N
LC-1R
WHITE
N
BLACK
BLUE
WHITE
BLACK
WiringDiagram#3
LC-1RD
120 VAC /277 VAC
EXISTING WIRINGEXISTING WIRING
EXISTING WIRING
N
LC-1RD
BALLAST (0-10VDC DIMMING)
H
N
BLACK
WHITE
BLUE
BLACK
WHITE
GR AY
VIOLET
EXISTING WIRING
WiringDiagram#2
LC-2R
120 VAC /277 VAC
RED
RED
BLACK
WHITE
BLUE
BALLAST #2
N
H
N
LC-2R
WHITE
N
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
EXISTING WIRING
120 VAC /277 VAC
BLACK
BALLAST #1
N
H
BLACK
WHITE
FIGURE #1
ADURATECHNOLOGIES
SanFrancisco,CA94105
Tel:415.227.0868•TollFree1-888-828-8281
TM
LOW VOLTAGE (MUST BE TREATED AS CLASS 1 WIRING)
5. Disconnect the hot wire to the ballast
(black for 120 VAC or brown for 277 VAC).