User's Manual

-
24 -
Rx Packet Count
Shows information of packets received successfully.
Rx Retry
Shows information of packets failed transmit after hitting retry
limit.
Rx ICV Error
Shows information of packets received with ICV error.
Reset
Click to reset counters to zero.
WPS
The primary goal of Wi-Fi Protected Setup (Wi-Fi Simple Configuration) is to simplify the security
setup and management of Wi-Fi networks. The STA as an Enrollee or external Registrar supports the
configuration setup using PIN (Personal Identification Number) configuration method or PBC (Push
Button Configuration) method through an internal or external Registrar.
WPS Tab
PIN Code
8-digit numbers. It is required to enter PIN Code into Registrar when using
PIN method. When STA is Enrollee, users can use "Renew" button to
re-generate new PIN Code.
Pin Input Config
(PIN)
Click the Pin Input Config (PIN) button to select specific AP to process PIN
Config.
Push Button Config
(PBC)
Click this button to connect with AP that supported WPS function within two
minutes. Meanwhile, the AP should also click the PBC button simultaneously.
About
This page displays the information of the WLAN Module Version.
Switch to AP Mode
To access the soft AP mode, please select the Mode on the function list of the Utility to make the
WLAN Module act as a wireless AP.
Soft AP mode
General
SSID
Shows the network name of the AP.
BSSID
Shows the MAC address of the AP.