Product Specs

W349E0WiFi IoE Module Page 7 of 9
5725-5850MHz PCB 5.537
3. Label and compliance information
Label of the end product:
FCC:
The host product must be labeled in a visible area with the following " Contains FCC ID:
HDC-W349E0".
The end product shall bear the following 15.19 statement: This device complies with part 15 of
the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
If the labelling area is considered too small and therefore it is impractical (smaller than the
palm of the hand) to display the compliance statement, then the statement may be placed in
the user manual or product packaging.
ISED:
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end
product must be labeled in a visible area with the following: “Contains transmitter module IC:
2250A-W349E0”.
Contient le module d'émission IC: 2250A-W349E0
The Host Model Number (HMN) must be indicated at any location on the exterior of the end
product or product packaging or product literature which shall be available with the end
product or online.
4. Information on test modes and additional testing requirements
This module is restricted to integration into hosts for indoor use only.
This module has been approved under stand-alone configuration.
The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093, RSS-102 and different antenna configurations
The information on how to configure test modes for host product evaluation for different
operational conditions for a stand-alone modular transmitter in a host, versus with multiple,
simultaneously transmitting modules or other transmitters in a host can be found at KDB
Publication 996369 D04.
5. Additional testing, Part 15 Subpart B disclaimer
Appropriate measurements (e.g. FCC 15 B and ISED compliance) and if applicable additional
equipment authorizations (e.g. SDoC) of the host product to be addressed by the
integrator/manufacturer.
This module is only FCC authorized for the specific rule part 15.407, RSS-247 listed on the
grant, and the host product manufacturer is responsible for compliance to any other FCC
rules that apply to the host product as being Part 15 Subpart B and ISED compliant.