Installation guide

ManualsBrandsADTRAN ManualsComputer equipmentVanta 1335

Option Modules NetVanta 1335 Series Hardware Installation Guide

NetVanta E1/FE1 NIM (P/N 1200868E1/L1)

The NetVanta E1/FE1 NIM (see Figure 8) provides a WAN-E1 interface for the NetVanta meeting the

requirements of ITU-T G.703/G.704. The module provides a single 2.048 Mbps network interface. Refer to

Appendix A on page 43 for WAN-E1 and DBU connector pinouts. An optional DIM is required for dial backup

applications.

Figure 8. NetVanta E1/FE1 NIM

WAN-E1 DBU

Features and Specifications

Operating Modes

• Frame Relay, Multilink Frame Relay

• PPP, Multilink PPP

• HDLC

WAN-E1 Interface

• Supported Standards: ITU G.703,

ITU-T G.704 (CRC-4), ITU-T G.823,

ITU-T G.797

• Line Rate: 2.048 Mbps +

50 PPM

• Line Code: AMI or HDB3

• Framing: FAS with optional CRC-4

• FE1 Line Rate: Channelized timeslot (in

multiples of 64 kbps)

• Receiver Sensitivity: -30 dB

• Connector: RJ-48C

Clock Source

•Network

•Internal

Diagnostics

• Test Pattern Generation and Detection:

QRSS, 511, all ones, all zeros

• Network loopbacks

• Network performance data (15 minutes and

24 hours)

• Alarm generation and detection

Compliance

• EMC - see Electromagnetic Compatibility

(EMC) Table on page 6.

•AS/ACIF S016

• ETSI TBR 12/TBR 13

• EN 60950

• IEC 60950

• AS/NZS 60950

• RoHS compliant (Telecommunications

exemption)

Environmental

• Operating Temperature: 0°C to 50°C

• Storage Temperature: -20°C to 70°C

• Relative Humidity: Up to 95 percent,

noncondensing

Physical

• Dimensions: 2.75-inch W x 4.25-inch D