User Manual
Table Of Contents
- Table of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Menu and System Control
- 3. Menu Descriptions
- > System Status
- > Main Menu
- > System Configuration
- > RF Link Configuration
- > RF Link Performance History (Main Screen)
- > RF Link Error History
- > RF Link Max/Min Received Power History
- > RF Link Min/Max Received Signal Quality History
- > Datapath Provisioning
- > 4xE1 Module Configuration/Status/History (Main Screen)
- > E1x Status/Configuration/Loopback
- > E1x Performance History
- > T1 Module Configuration/Status/History (Main Screen)
- > T1x Status/Configuration/Loopback
- > Ethernet Switch Module Configuration/Status/History (Main Screen)
- > Ethernet Switch Configuration
- > Ethernet Switch Status
- > Management/Utilities (Main Screen)
- > Ping Utility
- > Firmware Upgrade Utility
- > RF Link Management Bridge Configuration
- > System Alarms
- Detail Level Procedures
- MIBs
- Troubleshooting Guide
- 1. Overview
- 2. LED Indicators
- PWR LED
- TST LED
- RF DWN LED
- RF LOW LED
- T1 Interface Alarms
- E1 Interface Alarms
- 1. Display the E1(x) Status screen and check the E1(x) Interface Alarm field to identify the active alarm.
- 1. Verify that the E1 cable is connected to the E1 interface on the TRACER 64x0.
- 2. Verify the connections at the opposite end of the E1 cable.
- 3. Verify that the framing mode (framed, multiframed, or unframed) is the same for both the TRACER 64x0 and the E1 equipment.
- 2. Verify the cable connections for the E1 interface are solid.
- 2. Verify the cable connections for the E1 interface are solid.
- System Alarms
- LAN LEDs
- 3. RF Errors
- 4. Step-by-Step Troubleshooting
- 5. Installing/Troubleshooting the TRACER Hardware
TRACER 6000 Series Integrated System Manual Section 3 Engineering Guidelines
612806420L1-1E Copyright © 2005 ADTRAN, Inc. 39
Table 13. 4xE1 Module with 75Ω Interface DB-25 Connector Pinout
Pin Name Description
1 E1D RX Receive signal for E1 D interface
2 E1D TX Output signal for E1 D interface
3 GND Ground
4 E1C RX Receive signal for E1 C interface
5 E1C TX Output signal for E1 C interface
6 GND Ground
7 E1B RX Receive signal for E1 B interface
8 E1B TX Output signal for E1 B interface
9 GND Ground
10 E1A RX Receive signal for E1 A interface
11 E1A TX Output signal for E1 A interface
12-25 GND Ground
Table 14. DB-25 to 75Ω Unbalanced Cable Pinout
E1 Cable Interface
DB-25 Male
(TRACER Side)
DB-25 Male
(Breakout Panel)
Channel 1 Input 10 14
Channel 1 Output 11 3
Channel 2 Input 7 17
Channel 2 Output 8 6
Channel 3 Input 4 20
Channel 3 Output 5 9
Channel 4 Input 1 23
Channel 4 Output 2 12
Ground All other pins All other pins