User Manual
Table Of Contents
- Table of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Menu and System Control
- 3. Menu Descriptions
- > System Status
- > Main Menu
- > System Configuration
- > RF Link Configuration
- > RF Link Performance History (Main Screen)
- > RF Link Error History
- > RF Link Max/Min Received Power History
- > RF Link Min/Max Received Signal Quality History
- > Datapath Provisioning
- > 4xE1 Module Configuration/Status/History (Main Screen)
- > E1x Status/Configuration/Loopback
- > E1x Performance History
- > T1 Module Configuration/Status/History (Main Screen)
- > T1x Status/Configuration/Loopback
- > Ethernet Switch Module Configuration/Status/History (Main Screen)
- > Ethernet Switch Configuration
- > Ethernet Switch Status
- > Management/Utilities (Main Screen)
- > Ping Utility
- > Firmware Upgrade Utility
- > RF Link Management Bridge Configuration
- > System Alarms
- Detail Level Procedures
- MIBs
- Troubleshooting Guide
- 1. Overview
- 2. LED Indicators
- PWR LED
- TST LED
- RF DWN LED
- RF LOW LED
- T1 Interface Alarms
- E1 Interface Alarms
- 1. Display the E1(x) Status screen and check the E1(x) Interface Alarm field to identify the active alarm.
- 1. Verify that the E1 cable is connected to the E1 interface on the TRACER 64x0.
- 2. Verify the connections at the opposite end of the E1 cable.
- 3. Verify that the framing mode (framed, multiframed, or unframed) is the same for both the TRACER 64x0 and the E1 equipment.
- 2. Verify the cable connections for the E1 interface are solid.
- 2. Verify the cable connections for the E1 interface are solid.
- LAN LEDs
- 3. RF Errors
- 4. Step-by-Step Troubleshooting
- 5. Installing/Troubleshooting the TRACER Hardware
Section 7 MIBs TRACER 6000 Series Integrated System Manual
116 Copyright © 2005 ADTRAN, Inc. 612806420L1-1D
4. MIB VARIABLES SUPPORTED BY THE TRACER 64X0
Table 4. MIB Variables for ad.mi2
ad
adProducts
adProductInfo
adProdName DisplayString RO
adProdPartNumber DisplayString RO
adProdCLEIcode DisplayString RO
adProdSerialNumber DisplayString RO
adProdRevision DisplayString RO
adProdSwVersion DisplayString RO
adProdPhysAddress PhysAddress RO
adProdProductID
adProdTransType DisplayString RO
adMgmt
adAdmin
adPerform
adShared
adIdentity
adIdentityShared
adAgentCapModule
adAgentCapProduct
adAgentCapShared
adConformance
adCompliances
Table 5. MIB Variables for ads1.mi2
adDS1AlarmTable
adDS1AlarmEntry
adDS1AlarmIndex Integer RO
adDS1AlarmEnable Integer RW
adDS1LineEvent Integer RO
adDS1LineArm Integer RW
adDS1AlertTable
adDS1AlertEntry
adDS1AlertIndex Integer RO
adDS1AlertEnable Integer RW
adDS1CurrentAlert Integer RO
adDS1TotalAlert Integer RO
adDS1FarCurrentAlert Integer RO
adDS1FarTotalAlert Integer RO