User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
TRACER 4206 System Manual Section 5, User Interface Guide
612804206L1-1A © 2002 ADTRAN, Inc. 59
>T1D STATUS/CONFIGURATION/LOOPBACK > T1D LINE BUILD OUT
Configures the T1D for the appropriate line buildout, based on the distance to the T1D equipment.
>T1D STATUS/CONFIGURATION/LOOPBACK > ALARM REPORTING
Determines whether the TRACER 4206 unit will report active alarms. If DISABLED, no alarms will be
displayed on this menu page. The Alarm Reporting parameter is independently configured for local and
remote TRACER 4206 units. When
DISABLED, the front panel LED alarms will also be disabled (off).
>T1D STATUS/CONFIGURATION/LOOPBACK > SIGNALING
Configure the framing format for the T1D link for both the local and remote TRACER 4206 units. The
TRACER 4206 transports T1D data across the link (as long as the T1D signal is properly timed).
Configure the framing format (using the
SIGNALING menu) to enable the TRACER 4206 to monitor the
incoming framing error events and indicate problems with the attached metallic service. The TRACER
4206 supports both
ESF and D4 framing formats.
>T1D STATUS/CONFIGURATION/LOOPBACK > LINE CODE
Sets the line coding for the T1D link. The TRACER 4206 supports B8ZS and AMI line coding.
>T1D STATUS/CONFIGURATION/LOOPBACK > LOOP/NORMAL STATE
Controls the loop status of the T1D link. Activates/deactivates loopback conditions for testing purposes.
>T1D STATUS/CONFIGURATION/LOOPBACK > LOOP/NORMAL STATE > NORMAL
The T1D link is in normal data transport mode - there are no active loopbacks.
>T1D STATUS/CONFIGURATION/LOOPBACK > LOOP/NORMAL STATE > LINK
Activates a loopback at the TRACER 4206 T1D framer towards the wireless link (see Figure 20). Use the
LINK loopback to test data path integrity from one unit across the wireless link.
Figure 20. T1D Link Loopback
>T1D STATUS/CONFIGURATION/LOOPBACK > LOOP/NORMAL STATE > LINE
Activates a loopback at the TRACER 4206 T1D framer towards the wireless link (see Figure 21). Use the
LINE loopback to test data path integrity from the TRACER 4206 unit to the T1 equipment.
Figure 21. T1D Line Loopback