User Manual
Table Of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Terminal Menu and System Control
- 3. Menu Descriptions
- >TRACER System Status
- >Main Menu
- >TRACER System Configuration
- >TRACER Link Performance History
- >T1A Status/Configuration/Loopback
- >T1A Performance History
- >T1B Status/Configuration/Loopback
- >T1B Performance History
- >T1C Status/Configuration/Loopback
- >T1C Performance History
- >T1D Status/Configuration/Loopback
- >T1D Performance History
- Troubleshooting Guide
TRACER 4206 System Manual Section 5, User Interface Guide
612804206L1-1A © 2002 ADTRAN, Inc. 47
>TRACER SYSTEM CONFIGURATION > SITE NAME
Enter up to 25 alphanumeric characters to be displayed for identification of the TRACER 4206 system.
>TRACER SYSTEM CONFIGURATION > RF BANDPLAN
Sets the bandplan for the TRACER 4206. Each channel is divided into four Bandplans (1, 2, 3, or 4). Both
local and remote TRACER 4206 must be configured with the same bandplan (1, 2, 3, or 4) but different
channel plans (Plan A or Plan B). For example, the transmitter at one end of the link will transmit in
Bandplan 1 of the lower portion of the spectrum and receive in Bandplan 1 of the upper portion.
Consequently, the receiver at the other end should receive in Bandplan 1 of the lower portion and transmit
in Bandplan 1 of the upper portion (Refer to Figure 5)
Figure 5. RF Bandplan Bandwidth Division
>TRACER SYSTEM CONFIGURATION > MODEM CONTROL
Configures the modem control leads on the RS-232 port (terminal interface located on the rear panel of the
unit). Set MODEM CONTROL to ENABLED when connecting the unit to a modem (using a null modem
adapter). Setting MODEM CONTROL to DISABLED prevents the TRACER 4206 from monitoring DCD and
enables data to be sent to the VT 100 continuously.
MODEM CONTROL must be set to DISABLED when the
VT100 terminal is in use. The TRACER 4206 comes factory programmed with
MODEM CONTROL set to
DISABLED.
>TRACER SYSTEM CONFIGURATION > MODEM CONNECTION (LOGOUT)
Activator to cause the TRACER 4206 to de-assert Clear To Send (CTS) and DSR for a time greater than 20
milliseconds. This signals the modem to disconnect the analog connection. Hangup-On-DTR-Drop may
need to be explicitly enabled on some modems. If
PASSWORD PROTECTION is ENABLED, this menu also
causes the unit to close the current session and return to the TRACER System Status menu page and wait
for password input.
Press <Ctrl+Z> three times from the terminal interface to temporarily disable MODEM
C
ONTROL when the modem control leads are active.
Channel A
57345725 5787 58505744 5753MHz MHz
Band 3Band 2Band 1
Channel B
5814 5824 5833
Band 3Band 2Band 1